CC BY
17
AUNÎVERSUM:
TE>
№ 4 (109)_ДХ ТЕХНИЧЕСКИЕ НАУКИ_апрель. 2023 г.
DOI - 10.32743/UniTech.2023.109.4.15260 ANALYSIS OF THE DISPERSE COMPOSITION OF DUST OF COTTON CLEANING INDUSTRIES
Ikromali Karimov
Doctor of Technical Sciences (DSc), Associate Professor, Fergana Polytechnic Institute, Republic of Uzbekistan, Fergana
Bobirmirzo Qo'chqarov
Assistant,
Fergana Polytechnic Institute, Republic of Uzbekistan, Fergana E-mail: [email protected]
АНАЛИЗ ДИСПЕРСНОГО СОСТАВА ПЫЛЕЙ ХЛОПКООЧИСТИТЕЛЬНЫХ ЗАВОДОВ
Каримов Икромали Тожиматович
д-р техн. наук, профессор, Ферганский политехнический институт, Республика Узбекистан, г. Фергана
Кучкаров Бобирмирзо Улугбекович
ассистент,
Ферганский политехнический институт, Республика Узбекистан, г. Фергана
ABSTRACT
Annotation. The article determines the dispersion composition of dust in the air emitted into the atmosphere after cleaning from a cyclone device used at a cotton gin. A laboratory analysis was carried out to determine the percentage of dust by mass, as well as the median size of the dust emitted to the atmosphere. As a result, it became possible to determine the relative contact surfaces of dust particles. This, in turn, is important for comparison with the relative contact surface of the liquid droplets sprayed onto the device and for the correct choice of the ratio of liquid and gas flow rates.
АННОТАЦИЯ
В статье определен дисперсионный состав пыли в воздухе, выбрасываемой в атмосферу после очистки от циклонного устройства, используемого на хлопкоочистительном заводе. Проведен лабораторный анализ для определения процентного содержания пыли по массе, а также медианного размера пыли, выбрасываемой в атмосферу. В результате появилась возможность определять относительные контактные поверхности пылевых частиц. Это, в свою очередь, важно для сравнения с относительной контактной поверхностью распыляемых на устройство капель жидкости и для правильного выбора соотношения расхода жидкости и газа.
Keywords: cotton, dusty gas, wet method, liquid, dispersion composition, cyclone, percentage, average size.
Ключевые слова: хлопок, запыленный газ, мокрый способ, жидкость, дисперсионный состав, циклон, процентная доля, средний размер.
Introduction
Currently, in the cotton ginning industry, a large amount of dust is generated during the initial processing of cotton. As a result, it causes great damage to the environment. In addition, dust pollution of the air of production buildings has a great impact on the health of workers working there. Currently, single-stage and two-stage dust removal equipment are used in cotton ginning factories to remove dust from the environmental point of view. Dust from cotton ginning plants is sucked by a fan
and sent to cyclones, through which it is cleaned and released into the atmosphere. Cleaning efficiency of cyclones in cotton cleaning plants is 60-85% [4]. In cyclones, very small (1.0-10.0 ^m) dust particles escape into the atmosphere without being caught. The amount of dust in the air in the production buildings of the cotton ginning plant should not exceed 10 mg/m3. Dusty air released into the atmosphere is 300-350 mg/m3. It can be seen that the concentration of dust in the enterprise is much higher than the norm.
Библиографическое описание: Karimov I.T., Qo'chqarov B.U. ANALYSIS OF THE DISPERSE COMPOSITION OF DUST OF COTTON CLEANING INDUSTRIES // Universum: технические науки : электрон. научн. журн. 2023. 4(109). URL: https://7universum.com/ru/tech/archive/item/15260
№ 4 (109)
AunI
/Ш. ТЕ)
UNIVERSUM:
ТЕХНИЧЕСКИЕ НАУКИ
апрель, 2023 г.
Research object
It is important to determine the dispersion composition of the dust when determining the cleaning efficiency of the dust cleaning device recommended by us and determining the optimal values [1,2,3,5]. For this purpose, samples of dust cleaned by cyclones from the shops of the "Beshariq" cotton cleaning enterprise in Fergana region were analyzed according to the dispersion composition.
Obtained results
Dust samples caught in the process of cleaning dust in a cyclone in a cotton factory were taken out of the cyclone and 500 grams were weighed on a laboratory scale, and cotton fibers were separated into organic compounds (Figure 1).
A-Cotton fiber extractedfrom dust B-mineral and organic dusts
Figure 1. Dust samples from the cyclone
The dispersion composition and size distribution of these dusts were carried out in two stages: 1- by using a sieve and 2-microscopic laboratory analysis.
In the first step, the dust separated from the cyclone was subjected to 10-step sorting on a RETSCH-DIN-ISO 3310/1 brand sorting laboratory sieve (Fig. 2).
Sieve analysis
The size of sieve meshes was selected up to 850, 600, 425, 250, 125, 100, 75, 53 pm. Based on the obtained results, the dusts were divided into fractions in percentages (Table 1).
Table 1.
of dust sample
Sieve analysis of dust sample№ Dust size (micron) Dust mass 500 (g) Percentage share %
1 Bigger than 850 151,47 30,29
2 850>600 76,97 15,39
3 600>425 59,68 11,93
4 425>250 69,89 13,97
5 250>150 55,93 11,18
6 150>125 19,15 3,8
7 125>100 23,25 4,6
8 100>75 19,96 3,99
9 75>53 9,21 1,84
10 smaller than 53 14,88 2,97
In the second stage, the dusts were crushed for 5 minutes in the laboratory model of the LM-2E brand sieving device (runner) and were subjected to 7-stage
sorting for 5 minutes through the RETSCH-DIN-ISO 3310/1 brand sorting laboratory sieve. The size of the sieve meshes was selected up to 1, 3, 5, 10, 20, 40, 60 pm (Fig. 2).
№ 4 (109)
AunÎ
/Ш. TE)
UNIVERSUM:
ТЕХНИЧЕСКИЕ НАУКИ
апрель, 2023 г.
Figure 2. RETSCH-DIN-ISO 3310/1 sorting sieve laboratory device
Based on the obtained results, the dusts were divided into fractions in percentages. The following are the results of post-crushed laboratory analysis of cotton dust samples (Table 2).
Table 2.
Sieve analysis of dust sample in crashed condition
№ Dust size (micron) Dust mass (g) Percentage of total dust
1 0>1 10 2%
2 1>3 25 5%
3 3>5 45 9%
4 5>10 175 35%
5 10>20 190 38%
6 20>40 40 8%
7 40>60 15 3%
In the third stage, the method of optical microscopy was used to determine the dispersed composition of dust. The relative error of particle analysis in a biological microscope is ±1.5%. The relative error of the measurements to the average value is ±3.4%.
Figure 3. Overview of the BM-1800 biological microscope
№ 4 (109)
AunI
/Ш. ТЕ)
UNIVERSUM:
ТЕХНИЧЕСКИЕ НАУКИ
апрель, 2023 г.
In optical microscopy method, photographs were taken of each of the dust samples from the cyclone device and the crashed dust samples (Figures 4 and 5). A hair fiber was used as a scale to determine the size of the dust samples and fractionated in percentages. The average median size of a hair fiber is 40 pm. Photography was
carried out on a BM-1800 biological microscope (Fig. 3). Photo processing was done based on computer program. The magnification degree of the microscope is up to 400 times, the dimension of the dust samples was determined in percentages with comparison R100 pm interval relative to the hair fiber.
(Dust. 100 times) (Dust. 200 times) (Cotton fiber. 200 times)
Figure 4. Microscopic view of cyclone dust and cotton fiber samples
Magnified 400 times
Figure 5. Microscopic view of dust ejected from the cyclone into the atmosphere
Laboratory analyzes show that dust from cotton raw materials consists of organic and mineral fractions. Organic fractions consist of crushed particles of bush or cotton bolls and short cotton fibers [4].
The mineral fraction of dust consists of soil, sand and other impurities that enter cotton raw materials during harvesting, transportation and storage.
At the beginning of the technological process, during the transportation and weeding of raw cotton, mainly mineral dust is released and pollutes the air, and at the end of the technological process, especially during lint-ing and pressing, organic dust is released. The exhaust air of the pneumatic transport system of cotton raw materials contains 10-20% of the total dust content and 8090% of mineral dust. According to sieving and microscopic analysis of dust samples from the cyclone, particles smaller than 53 pm make up 3% of the total dust mass. When the dust samples were sieved and analyzed
by microscopy, the amount of dust smaller than 10 microns was 51%. It follows that the fraction of dust entering the cyclone with sizes smaller than 10 pm leaves without cleaning.
The cleaning efficiency of wet vacuum cleaners depends on the size of the dust, which has different sizes in the size range. This, in turn, causes difficulties in determining the relative surfaces in contact with liquid droplets, depending on the size of the dust. Therefore, it is desirable to calculate by determining the contact surfaces in relation to the individual dust size.
The results of laboratory analysis determined by the method of sorting dust samples on a sieve and microscopy were processed on the basis of a computer program, regression equations were obtained, and a graph of the change in the percentage of dust was constructed depending on the distribution of the dispersed sizes. (Figure 6).
№ 4 (109)
AunÎ
/Ш. TE)
UNIVERSUM:
ТЕХНИЧЕСКИЕ НАУКИ
апрель, 2023 г.
Figure 6. The graph of the change of the percentage of dust samples depending on the dispersed content
The resulting regression equations look like this:
y = 9,7178e°'051x R2 = 0,984773
In the calculations, we assume that the dust samples are spherical and determine the relative (median) diameters of the isolated dust through a horizontal line that makes up 50% of the total dust (see Figure 6). In this case, the values of dm were determined by drawing a vertical line from the intersection point of the graph drawn for dust samples with a horizontal line. It can be seen from the graph that the median size of dust samples is dm=10 Mm.
Conclusion
The error between the results of the laboratory analysis between the sieving and the microscopy method on the dust samples taken from the cotton factory was ±5%. As a result of laboratory studies, the average median size of dust particles was determined. Depending on these dimensions, the cleaning efficiency of wet dust cleaning devices is determined according to the volume surface diameters of dust and the amount of water supplied in relation to the dust content of 1 m3 of air or gas.
References:
1. Ikromali T.Karimov, Bobirmirzo U. Kochkarov "WET METHOD DUST GAS CLEANING DEVICE" Proceeding VIII International Conference "Industrial Technologies and Engineering" ICITE - 2021, Volume II. M. Auezov South Kazakhstan University, Shymkent, Kazakhstan November 10-11,2021.
2. Ikromali K., Bobirmirzo Q.C. RESISTANCE COEFFICIENTS OF THE APPARATUS WITH CONE MESH WET CLEANING OF DUST GASES // Universum: технические науки. - 2023. - №. 1-5 (106). - С. 8-13.
3. Каримов И.Т., ^уч^аров Б.У. "Чангли газларни хул усулда тозаловчи янги аппарат" Фаргона политехника институти илмий - техника журнали Scientific-technical journal (STJ FerPI, ФарПИ ИТЖ, НТЖ ФерПИ, 2021, T.24, спец. № 1.
4. Справочник по первичной обработке хлопка книга 2, Ташкент «Мехнат» -1995 246-247 с.
5. Tojimatovich K.I., Ulugbekovich K.B. Wet Method Dust Gas Cleaning Device // The American Journal of Engineering and Technology. - 2021. - Т. 3. - №. 10. - С. 20-26.
